ABSTRACT
Reverse transcription-PCR (RT-PCR) is the standard method of diagnosing COVID-19. An inconclusive test result occurs when one RT-PCR target is positive for SARS-CoV-2 and one RT-PCR target is negative within the same sample. An inconclusive result generally requires retesting. One reason why a sample may yield an inconclusive result is that one target is at a higher concentration than another target. It was hypothesized that concentration differences across targets may be due to the transcription of sub-genomic RNA, as this would result in an increase in the concentration of gene targets near the 3 end of the SARS-CoV-2 genome. A panel of six digital droplet (dd)PCR assays was designed to quantitate the ORF1, E-gene, and N-gene of SARS-CoV-2. This panel was used to quantify viral cultures of SARS-CoV-2 that were harvested during the eclipse phase and at peak infectivity in such a way as to maximize gene-to-gene copy ratios. Eleven clinical nasopharyngeal swabs were also tested with this panel. In culture, infected cells showed higher N-gene/ORF1 copy ratios than culture supernatants. Both the highest specific infectivity (copies/pfu) and the highest differences between gene targets were observed at 6 hours post-infection (eclipse phase) in infected cells. The same trends in the relative abundance of copies across different targets observed in infected cells was observed in clinical samples, though trends were more pronounced in infected cells. This study showed that a greater copy number of N-gene relative to E-gene and ORF1 transcripts could potentially explain inconclusive results for some RT-PCR tests on low viral load samples. The use of N-gene RT-PCR target(s) as opposed to ORF1 targets for routine testing is supported by this data. Author SummaryThis paper provides insight into a drawback of the standard method of testing for COVID-19 (RT-PCR). The results presented here propose an explanation for why inconclusive results sometimes occur with this method. These results can aid microbiologists in the interpretation of inconclusive test results. These results can also aid in decisions about which COVID-19 test a laboratory should use, as there are a plethora of options available. This is important because this standard testing method will remain a critical tool - globally - for managing the COVID-19 pandemic and any future viral pandemics and epidemics. Thus, it is important to investigate every facet of the testing method. The findings presented here are applicable to any virus which makes sub-genomic transcripts as part of its life cycle. Trends observed in viral cultures are presented alongside the same trends observed in clinical samples. Unlike similar papers in the field, this paper did not strive to develop a new methodology or tool.
Subject(s)
COVID-19ABSTRACT
Background: SARS-CoV-2 has been detected in wastewater and its abundance correlated with community COVID-19 cases, hospitalizations and deaths. We sought to use wastewater-based detection of SARS-CoV-2 to assess the epidemiology of SARS-CoV-2 in hospitals. Methods: Between August and December 2020, twice-weekly wastewater samples from three tertiary-care hospitals (totalling >2100 dedicated inpatient beds) were collected. Wastewater samples were concentrated and cleaned using the 4S-silica column method and assessed for SARS-CoV-2 gene-targets (N1, N2 and E) and controls using RT-qPCR. Wastewater SARS-CoV-2 as measured by quantification cycle (Cq), genome copies and genomes normalized to the fecal biomarker PMMoV were compared to the total daily number of patients hospitalized with active COVID-19, confirmed cases of hospital-acquired infection, and the occurrence of unit-specific outbreaks. Results: Of 165 wastewater samples collected, 159 (96%) were assayable. The N1-gene from SARS-CoV-2 was detected in 64.1% of samples, N2 in 49.7% and E in 10%. N1 and N2 in wastewater increased over time both in terms of amount of detectable virus and the proportion of samples that were positive, consistent with increasing hospitalizations (Pearsons r=0.679, P<0.0001, Pearsons r=0.728, P<0.0001, respectively). Despite increasing hospitalizations through the study period, wastewater analysis was able to identify incident nosocomial-acquired cases of COVID-19 (Pearsons r =0.389, P<0.001) and unit-specific outbreaks by increases in detectable SARS-CoV-2 N1-RNA (median 112 copies/ml) versus outbreak-free periods (0 copies/ml; P<0.0001). Conclusions: Wastewater-based monitoring of SARS-CoV-2 represents a promising tool for SARS-CoV-2 passive surveillance and case identification, containment, and mitigation in acute- care medical facilities.
Subject(s)
COVID-19ABSTRACT
Saliva samples were collected through a simple mouth wash procedure and viral load quantified using a technology called digital droplet PCR. Data suggest ddPCR allows for precise quantification of viral load in clinical samples infected with SARS-CoV-2.
ABSTRACT
We have developed a reverse-transcriptase loop mediated amplification (RT-LAMP) method targeting genes encoding the Spike (S) protein and RNA-dependent RNA polymerase (RdRP) of SARS-CoV-2. The LAMP assay achieves comparable limit of detection as commonly used RT-PCR protocols based on artificial targets, recombinant Sindbis virus, and clinical samples. Clinical validation of single-target (S gene) LAMP (N=120) showed a positive percent agreement (PPA) of 41/42 (97.62%) and negative percent agreement (NPA) of 77/78 (98.72%) compared to reference RT-PCR. Dual-target RT-LAMP (S and RdRP gene) achieved a PPA of 44/48 (91.97%) and NPA 72/72 (100%) when including discrepant samples. The assay can be performed without a formal extraction procedure, with lyophilized reagents which do need cold chain, and is amenable to point-of-care application with visual detection.